Bushmaster M17s Cheek Rests

Cheek Rest Original

Cheek Rest $35
Made out of high strength heat resistance Kydex material. Comes with longer screws to attach to the existing threads in the bolt rail on your Gen 2. This cheek rest will work with your OEM charging handle. It will only work with certain charging handles that I make.


Cheek Rest High Mount

Cheek Rest High Mount $45
Made out of high strength heat resistance Kydex material. Comes with longer screws to attach to the existing threads in the bolt rail on your Gen 2. Used with higher rails and with high mounted scopes. This will NOT work with your OEM charging handle and will only work with certain charging handles that I make.

 


Install instructions: The 4 screws are installed from the factory with red loctite so it makes it difficult to remove them. The best way I have found is to apply a good amount of heat with a heat gun directly to the screws to soften the Loctite. If you use a heat gun it will not discolor the receiver like a torch will. Remove the screws while they are still hot. I then chase the threads with a 8-32 tap to clean out the threads. Then install the cheek rest with the supplied screws and blue loctite.